9
To assure smooth, efficient
performance, it is important
to clean your shaver.
Daily
Brush inside the
head assembly
after each use:
1.
Turn the shaver
off.
2.
Grip the head
assembly by
the three ridges
and pull it off the
shaver.
3.
Use the clean-
ing brush to
sweep out the
internal part of
the head assem-
bly and the hair
pocket area,
where 3 shaver
spindles are
located.
4.
Replace head assembly.
Weekly
Clean under the cutter assembly at
least once a week:
1.
Turn the shaver off.
2.
Open the head assembly as above.
3.
Unscrew the center screw knob
to remove the cutter retainer
assembly.
4.
Use the cleaning brush to sweep
the dust and hairs from under the
cutters.
5.
Replace head assembly.
Cleaning Cautions
■
The construction of this shaver
is for dry operation only. It is
not waterproof. Never put the
shaver partially or completely
into water.
■
Never clean the shaver or
replace the cutters while it is
plugged into an electrical outlet.
■
Do not use an aggressive cleansing
agent as this may destroy the
shaver coatings.
■
Do not clean or remove the head
assembly while the shaver is running
or plugged in, as it may cause dam-
age to the unit's heads or cutters.
■
Replace worn or damaged parts
with Remington
®
replacement
parts only.
8
When is it Time to Replace
Your Heads and Cutters?
It is very important to replace your
heads and cutters when necessary
to ensure a close, comfortable
shave without irritation. We recom-
mend they be replaced every 12
months. Here are some signs of
head and cutter wear, indicating
that replacement is needed.
Irritation
As the heads get excessively worn
you may experience some skin
irritation. This would be especially
noticeable when you apply
after-shave lotion.
Pulling
When the cutters wear you may
feel a sense of pulling and a loss
of closeness when you shave. This
is an indication that it is time to
replace your heads and cutters.
The replacement parts for your
shaver is model SP-25.
U.S. residents: To order, contact
us at 800-231-8793, visit us at
www.remington-products.com
or visit your local retailer.
Canadian residents: For any shaver
accessory requirements, please
call800-268-0425 or visit us at
www.remington-products.com
Head/frame
assembly
Floating
cutter
heads
Locating pins
Cutter retainer
assembly
Center
screw
knob
Locating holes
Lubricate
Remington
®
Shaver Saver
®
Lubricant
(SP-4) lubricates and cleans your
shaver's cutters and head assembly.
The lubricant helps remove hair clip-
pings while reducing wear. A quick
spray after each shave keeps your
shaver operating at peak performance.
!
Important:
Make sure to align
the two locating holes in the Cutter
Retainer assembly with the pins in
the Head Frame Assembly. (See
illustration below). Then tighten
center screw knob to lock the
cutters into place.
Replace head assembly on the shaver
simply by pushing it onto the shaver.
Cover shaver head with plastic head-
guard between uses. When removing
the headguard or placing it back onto
the shaver,do not apply pressure to
floating cutter surfaces, as you may
damage them.
Cleaning and Maintenance
Microflex R_200_400_IB 8/24/06 2:34 PM Page 8
