Page 5
Assembly
NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING OR WHILE CONNECTED
TO A POWER SOURCE
Kerosene
Forced Air Heaters
Front Handle
Wheel Support Frame
Axle
Rear Handle
Figure 3.
Component Identification
Model
HH-400T-KFA
Wheel Support Frame
Yes
Wheels and Axle
Yes
Wheel Caps
Yes
Front Handle
Yes
Rear Handle
Yes
Cord Wraps
Yes
Screws, Nuts and Washers
Yes
Cotter Pins and Bushings
Yes
Wheels
(Pneumatic)
Wheel Caps
(Black Rubber)
Screws (L) Flat Washers (S) Flat Washers (L)
Screws (S)
Cotter Pins
Bushings
Nuts
Cord Wraps
TOOLS REQUIRED
•
MEDIUM PHILLIPS SCREWDRIVER
•
OPEN OR ADJUSTABLE WRENCH, USE US (INCH) SCREWS
NUTS
•
LONG NOSE PLIERS
ASSEMBLING WHEEL & HANDLE
1. Slide axle through wheel support frame. Install wheel bushings,
flat washers (S) and wheel on axle.
NOTE:
When installing wheels, tube valve should face out from
support frame (Figure 5).
2. Place flat washers (L) and cotter pins on axle ends and bend
cotter pins with long nose pliers to secure.
3. Place wheel cap on flat washers (L) and put wheel cap in flat
washers (L) end.
4. Place heater on wheel support frame. Make sure air inlet end
(rear) of heater is over wheels. Align the holes on fuel tank
flange. Insert screws through handles (front and rear), fuel tank
flange, and wheel support frame as shown in Figure 5 and
attach nut finger tight after each screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
Do not operate heater without support
frame fully assembled to tank.
CAUTION
©2014 Pinnacle Products International, Inc. Kerosene Heater User’s Manual
