![background image](http://html.mh-extra.com/html/remington/hc535/hc535_manual_1437856011.webp)
ENGLISH
5
GB
D
NL
F
E
I
DK
S
FIN
P
SK
CZ
PL
HU
N
RU
TR
RO
GR
SL
AE
HR/ SRB
GB
AUTO BOOST SYSTEM (Only for HC5750)
There are 3 settings for the Auto Boost system: Off, Auto and Boost.
If the clipper is set to Auto it will run at regular power under low load conditions.
When more power is needed, the clipper with automatically sense and provide maximum
Boost.
If the clipper is set to Boost, it will run at maximum power at all times.
DUAL BOOST SYSTEM (Only for HC5550)
There are 3 settings for the Dual Boost system: Off, On, Boost.
If the clipper is set to On, it will run at regular power.
If the clipper is set to Boost, it will provide maximum power.
CARE FOR YOUR HAIRCLIPPER
Your clipper is fitted with high quality blades. To ensure long lasting performance of your clipper,
clean the blades and unit regularly. Always keep the attachment guide comb on the trimmer
blade.
AFTER EACH USE
Ensure the clipper is switched off and disconnected from the mains.
Brush the accumulated hair from the blades. Do not submerge the clipper in water.
To clean the unit, wipe with a damp cloth and dry immediately.
Note: Ensure that the clipper is turned off when cleaning.
WASHABLE CLEANING
The QUICK WASH SYSTEM is designed to maximise the efficiency of washable cleaning.
Click the buttons that are located on the sides of the hair clipper head. The blades will slide
out and the blade set can easily be cleaned under the tap.
Once the blades are cleaned the blades are locked into place by pushing the blade set
towards the hair clipper head and will snap into place.
Do not run the entire unit under the tap, only the blade set is meant to be submerged in
water.
Note: Ensure that the hair clipper is turned off when cleaning.
EVERY SIX MONTHS
At regular intervals the Blade Set should be removed and cleaned.
Remove the 2 screws retaining the fixed blade with a screwdriver. Do not remove blade set.
Brush out hairs from between the blades with soft cleaning brush. Do not remove the
lubricating grease from the blades. It is not necessary to remove the small moving blade
from the unit.
If the moving blade has been removed this can be re-fitted by slotting the ceramic coated
blade holder over the pin in the centre of the interior product head. The groove on the
ceramic coated blade, just below the teeth, rests on a metal plate at the opposite side to
100158_REM_IFU_HC5350_21L.indd 5
100158_REM_IFU_HC5350_21L.indd 5
26.03.10 11:32
26.03.10 11:32