![background image](http://html.mh-extra.com/html/remington/hc4110/hc4110_manual_1437844006.webp)
6
ENGLISH
SHORT LENGTH SELECTION LEVER
• Your hair clipper has a short length selection lever located on the back of the hair
clipper, under the blade set. Adjust the lever to change the closeness of the cut
gradually and also to improve the effectiveness of the trimming guide attachments.
Using the lever also extends the life of the blades because a different cutting edge is
used in each setting.
CARE FOR YOUR HAIRCLIPPER
AFTER EACH USE
• To ensure long lasting performance of your clipper, clean the blades and unit regularly.
• Ensure the appliance is switched off and unplugged from the mains before cleaning.
• Brush the accumulated hair from the blades and body of the clipper. Do not submerge
the clipper in water.
• We recommend oiling the blades after cleaning with a little sewing machine oil.
• Note: Ensure the clipper is turned off when cleaning.
EVERY SIX MONTHS
• Ensure that the clipper is discharged of all power and disconnected from the mains.
• Hold the hair clipper in one hand so that the blades are at the top, and the front of the
hair clipper is facing you.
• Place your thumb of the opposite hand underneath the blades at the front of the unit,
hold the back of the blade set with your fore finger and middle finger and firmly press
upwards with your thumb. The blade set will detach from the hair clipper.
• Brush the accumulated hair from the hair pocket and blades.
• Replace the blade set by inserting the notch (on the inside at the bottom of the blade
set) into the groove of the hair pocket and firmly push down with the palm of your hand
until you hear an audible ‘click’ and the blade set is locked into place. (Please be aware
that the short length selection lever on the back of the blade set is not the notch which
needs to be placed into the groove).
REMOVING THE RECHARGEABLE BATTERY
We strongly recommend that a professional removes the rechargeable battery. Parts of the
shaver case, and tools have sharp edges and may cause injury if not handled correctly.
• The rechargeable battery must be removed from the appliance before it is scrapped.
• Disconnect the charging adapter before removing the battery.
1. Ensure that the battery is fully discharged. To do this, operate the device until it stops.
2. Remove the blade assembly.
3. Remove the 3 screws from rear housing.
4. Pry open the top housing.
5. Pry and open the top housing.