will illuminate once again to indicate power source connection. Either leave the clipper
connected to complete a full charge (16 hours) or disconnect it from the mains for
storage if you are finished using it.
CAUTION: Extended mains (corded) only use will result in the reduction of the
battery life.
HOW TO USE
BEFORE STARTING TO CUT
1.
Inspect the hair clipper making sure that it is free from hair and dirt.
2.
Ensure that the hair is thoroughly dry and tangle free.
INSTRUCTIONS FOR HAIR CUTTING
NOTE: For even cutting, allow the trimmer comb/blade to cut its way through
the hair. Do not force it through quickly. If you are cutting for the first time,
start with the maximum length trimmer comb, until you know how short you
would like your hair to be.
NOTE: The comb guide lengths described for use in the steps below are an
example only, if you want a longer or shorter hair cut you will need to adjust
the comb guide lengths to suit your requirements.
STEP 1 - NAPE OF THE NECK
a.
Use 3mm or 7mm guide comb.
b.
Hold the hair clipper with the blade teeth pointing upwards. Begin starting at the
centre of the head at the base of the neck.
c.
Slowly lift the hair clipper, working upwards and outwards through the hair,
trimming just a little at a time.
STEP 2 - BACK AND SIDE OF THE HEAD
With the 9mm or 12mm guide comb attached, cut the hair at the back of the head.
STEP 3 - SIDE OF THE HEAD
a.
With the 9mm or 12mm guide comb attached, trim sideburns.
b.
Then change to the longer 25mm guide comb and continue to cut to the top of
the head.
STEP 4 - TOP OF THE HEAD
a.
Attach the 25mm guide comb, cut the hair on top of the head against the direction
in which the hair normally grows.
b.
For longer hair on top, use scissors. Lift the hair on top of the head with a styling
comb. Cut over the styling comb with the hair lifted or hold the hair between the
fingers to lift it and cut it to the desired length.
c.
Always work from the back of the head.
6
