Remington Durablade Pro MB070, User Manual

Page: 4 / 88

4
CHARGE LEVEL INDICATORS
Charge Level Indicator
Charging LED shows solid
Low charge LED flashes rapidly
Full charge LED will turn off
• Run time from fully charged is up to 60 minutes.
• Charge time from empty is 4 hours.
Note: To preserve the life of your batteries, let them run out every 6 months then fully
charge.
INSTRUCTIONS FOR USE
Switch the product on by pressing the On/Off switch.
Always comb your beard or moustache with a fine comb before you start trimming.
CHANGING BLADE HEADS
1. To remove a blade head, twist it anticlockwise and pull it away from the body.
2. To refit, place the blade on to the body and twist it clockwise until it locks.
ATTACHING AND REMOVING THE COMBS
1. Select the desired trimming length comb. Place the comb over the top of the blade and
gently push this down onto the blade until it clicks into place.
2. To remove the comb, grasp the comb and pull firmly upwards and away from the
groomer.
TO TRIM THE BEARD
1. Select your desired trimming length comb. If you are trimming for the first time start
with the maximum trimming length setting.
2. Turn the unit on.
3. Place the flat top of the fixed comb against the skin.
4. Slowly slide through the hair. Repeat from different directions as necessary.
5. If hair builds up in the trimmer comb during the trimming process, switch the unit off,
pull off the comb and brush the hair off.
TO GET A SHAVEN LOOK
To trim any length of beard or stubble hair for a clean, shaven look then follow the above
steps without a comb attached to the blade head.
Place the flat top of the blade against the skin and slowly slide through the hair against the
direction of growth.
ENGLISH