Remii 102745-XT, Assembly, Installation And Operation Instructions

Page: 19 / 25

19
REM OTE CONTROL OPERATION
For remot e t o funct ion make sure t he heat er is plugged in and main power sw it ch located on t he
bott om left hand side is at posit ion I.
When operat ing t he remot e make sure you point t he remote t o t he cent re of t he fireplace and make
sure each t ime you press t he butt on t he buzzer inside t he unit w ill beep once. It t akes some t ime for
t he receiver t o respond t o t he t ransmitt er. Do not PRESS t he butt ons more t han once w it hin t wo
seconds for correct operat ion.
Power on butt on: The power-on but t on at t op left corner of t he remot e is t he main ON/ OFF
power butt on. This w ill t urn off all t he funct ions and t he fireplace w ill be in st andby mode.
DISPLAY ON/OFF button
: Sw it ching t he fireplace flame and t ray light ON/ OFF. It has funct ions of
set t ing memory.
DISPLAY BLUE button : Adjust the blue color brightness of flame and tray.
DISPLAY YELLOW button : Adjust the yellow color brightness of flame and tray.
DISPLAY ORANGE button : Adjust the orange color brightness of flame and tray.
M OOD LIGHT ON/ OFF button : Sw it ching t he mood light ON/ OFF.
ADJUST button
: Sw it ching t he color of t he mood light .
FLASH button : Sw it ches t he mood light into flash mode, t his cycles t hrough all mood light colors.
HEATER ON/OFF button : Switching the heater ON/OFF. It has functions of setting memory.
HIGH button : Press the high button to switch the heater to high heat setting 1500W.
LOW button : Press the low button to switch the heater to low heat setting 750W.
TEMP. button : Press the TEMP. button to switch the heater to AUTO mode. Under this mode
the heater will operate in similar way as explained above for the manual operation.