1. Navigate to the Installer menu.
Note
The Installer menu is available only when the icon flashes.
2. Press the
key to open the Installer menu.
3. Keep pressing the key until the code
is displayed.
4. Press the
key to confirm opening the Installer menu.
The parameters available to the Installer are displayed.
5. Keep pressing the key until
is displayed.
6. Press the
key to carry out the auto-detect.
7. After a while, the main display is shown again.
7.3 Reading out current values
1. Navigate to the Information menu.
2. Press the
key to open the Information menu.
Note
The Information menu is available only if the icon flashes.
3. Press the or key to display the required information.
4. Press the
h
key twice to go back to the main display.
Tab.6
Current values
Value
Description
Unit
DHW active
-
Status
-
Sub-status
-
Circulation pump (0 = no pump connected)
-
Flow temperature
°C
Heat exchanger temperature
°C
Return temperature
°C
Hydraulic pressure
bar
Heat demand on/off (0 = no heat demand)
-
Output
%
Outside temperature (only if an outside temperature sensor is connected)
°C
Analogue input (0-10 V)
V
Outside temperature sensor connected
-
Fan rotation speed
rpm
Fan rotation speed (set point)
rpm
Gas pressure control GPS
-
Ionisation current
uA
Gas leakage control VPS
-
Fig.89 Accessing the Installer menu
MW-3000312-01
Fig.90 Entering the code
MW-3000313-01
Fig.91 Confirming the Installer menu
MW-3000314-01
Fig.92 Accessing the Information menu
MW-3000306-01
Fig.93 Displaying information
MW-3000307-01
Fig.94 Back to the main display
MW-3000308-01
7 Settings
22
7616014 - v.03 - 15022016
