Press and
ESCAPE.
The Programmer’s
display will show a characteristic Test Pattern with
all segments on, thus:
and then revert to:
in the display when
ESCAPE is
released.
After Programming or Cloning is completed:
1. Turn Transceiver power
2. Remove inter-connecting cable from
transceiver.
This feature permits duplicating (cloning) the same
programmed data into any number of transceivers.
Be sure to use the proper Start-up (see PRELIMI-
NARIES, page 5) and Unit Turn Off procedures
(above) when cloning.
NOTE:
The
CLONE
key toggles from the
Read
function to the
Wrlte
function, or
vice
versa,
each time it is pressed.
If a Transceiver
a/ready
contains the data to be
cloned, connect it to the PM4500 and proceed with
Step 3 on page 26, using proper Start-up proce-
dure.
