Reliable MAVEN 100IS, Instruction Manual

Page: 12 / 48

FILLING THE BOILER DURING USE
Turn the boiler off pressing the switch (L) before unscrewing the cap (B).
Press the steam button (D) on the iron and allow all the steam to escape. The iron
must not be on its stand during this operation.
Switch off the iron by pressing the (O) button.
Disconnect the power supply cable from the outlet (Fig. 2). Let the appliance
to cool down for a few minutes. Rotate the boiler cap (B) counter-clockwise
very carefully and wait for the residual steam to stop hissing before emptying it
completely (Fig. 8).
Top up the boiler using the funnel (J) provided (Fig. 3).
Replace the cap (B) and screw it in a clockwise direction, ensuring that it is
completely tight.
WARNING: Never unscrew the cap of the boiler while the appliance is connected to
an electrical outlet or when there is still pressure inside. Never unscrew the cap of
the boiler while you are ironing. If the iron has not been used for a long time, it is
advisable to keep it in a horizontal position and press the steam button (D) for 30
seconds in order to clean the inner dispensing lines of the iron. Do not carry out
this operation when the iron is on its stand (I). For a short ironing session, it is not
necessary to fill the boiler completely. In fact, less water in the boiler will reduce
the waiting time, and consequently electric energy consumption.
VERTICAL IRONING
You can use the jet of continuous steam for ironing hanging fabrics. This special
ironing procedure serves to remove creases from curtains, fabrics, etc... Set the
ironing temperature by turning the adjustment knob (F) past the symbol (•••). Put
the curtain or fabric in the position you would like to iron it vertically and press
the steam button.
WARNING: Do not direct the steam jet towards people, animals or iron clothes
when they are being worn, as this could be dangerous.
DRY IRONING
To iron dry - i.e. without steam - all you have to do is turn the iron on by pressing
the switch (O) after connecting it to the power supply. Place the steam adjustment
knob on minimum and turn the thermostat knob (F) to the desired temperature.
Do not press the steam button.
09