Ordering Information
Specify:
1. Sprinkler: [Model F3-80 Dry Pendent SIN RA6012]
[Model F3-80 Dry Horizontal Sidewall SIN RA6032]
2. Escutcheon/Cover Plate: [None][Standard
escutcheon][Model HB extended escutcheon][Model
FP recessed escutcheon][Model CCP cover plate –
pendent only]
3. Inlet Threads: [1” NPT][ISO7-1R1]
4. Inlet Fitting: [Long – Standard Inlet Fitting][Short “PL”
– Wet Pipe Systems only]
5. Sprinkler Temperature Rating: See Temperature
Ratings table
6. Sprinkler Finish: See Finishes Table
7. Escutcheon/Cover Plate Finish: See Finishes Table
8. Length: “A” Dimension (face of tee to face of ceiling
or wall) in ¼” (6 mm) increments – See Fig. 1 through
Fig. 7
Note:
The “A” dimension is based on a nominally gauged pipe
thread “make-up” of .600” (15mm) per ANSI B2.1 [approxi-
mately 7 ½ threads].
Installation Data
Sprinkler Model
Escutcheon or Cover Plate
Suggested Hole Diameter in Wall or Ceiling
Installation Wrench
F3-80 Dry
Standard Escutcheon
2-1/8” (54 mm)
F3R
HB Extended Escutcheon
2-1/2” (64 mm)
FP Recessed Escutcheon
2-1/2” (64 mm)
XLO2
CCP Cover Plate (Pendent Only)
Maintenance
The Model F3-80 Dry Sprinklers should be inspected and the
sprinkler system maintained in accordance with NFPA 25.
Do not remove the factory applied thermally sensitive wax
fillet between the bulb supporting cup and the wrenching
boss. Do not replace this wax with a substitute substance.
An Alternate substance may interfere with proper operation
of the sprinkler. Do not clean sprinklers with soap and water,
ammonia or any other cleaning fluids. Remove dust by using
a soft brush or gently vacuuming. Replace any sprinkler
which has been painted (other than factory applied) or
damaged in any way. A stock of spare sprinklers should
be maintained to allow quick replacement of damaged or
operated sprinklers. Prior to installation, sprinklers should be
maintained in the original cartons and packaging until used
to minimize the potential for damage to sprinklers that would
cause improper operation or non-operation.
Reliable Automatic Sprinkler Co., Inc.
(800) 431-1588
Sales Offices
(800) 848-6051
Sales Fax
(914) 829-2042
Corporate Offices
www.reliablesprinkler.com Internet Address
Manufactured by
Recycled
Paper
Revision lines indicate updated or new data.
EG. Printed in U.S.A. 04/20
P/N 9999970500
The equipment presented in this bulletin is to be installed in accordance with the latest published Standards of the National Fire Protection Association, Factory
Mutual Research Corporation, or other similar organizations and also with the provisions of governmental codes or ordinances whenever applicable.
Products manufactured and distributed by Reliable have been protecting life and property for almost 100 years.
Summary of Contents for F3-80 Dry Horizontal Sidewall
Page 10: ...10 Fig 8...
Page 11: ...Fig 9 11...
Page 12: ...Fig 11 Model XLO2 Wrench Fig 10 Model F3R Wrench 12...
Page 13: ...Fig 12 13...