RESTORING WHEN POWER CUT
LANGUAGE SETTING
Language Setting
Under the below situations, it needs to reset IP:
1) Change the hand held controller.
2) The hand held can't start the corresponding function, or always showing
communication error.
1.Press the address restoration switch of the inside steam resource box of the
mattress for 3 seconds, when there is ringing sound of [BI] , [BI]
it shows the
communication address of the main controller is restored.
The schematic diagram of the address restoration switch on the steam resource
box inside the mattress.
.Steps for setting communication password of mattress.
WARNING
When power off unusual, push this
botton reset the mattress
Please make sure this botton in off
posintion, when you are using any
function
Air releasing
Switch
When the power cut, and the mattress at the lifting state, press the recovery button
to make the mattress restore to flat state.
SET REMOTE COMMUNICATION ADDRESS CODE
1.Into Chinese/ English display optional interface
In standby state, press
button and the back lift
button at the same time, then release, into Chinese/
English display optional interface.
Auto
AUTO
AUTO
NECK&
SHOULDER
AUTO
2.Choose the language you need
Pressure the function button
(rise) and
(down) to choose,
the pressure
button, it will be ok.
AUTO
Bed Rise/Fall
Control
Bed Rise/Fall
Control
Bed Rise/Fall
Control
Bed Rise/Fall
Control
Bed Rise/Fall
Control
3) Adjust the angle of the backrest and calf rest together
Lay down and press the button at the massage condition, the
backrest and calf rest will drop together, with dripping sound at
the same time.(If it was no reaction within two minutes, then you
can press this button again to turn it off). Press this button again
to stop it.
THE ADJUSTMENT OF THE ANGLE BETWEEN BACKREST AND CALF-REST OF BED BASE
2) Adjust the degree of the calf rest
Back up button: press this button when turn on the power, the legs will up
gradually, with dripping sound at the same time. (During two minutes this button
not touched or mattress go to the top position, the power will be off automatically.).
Press this button again to stop it.
Back down button: press this button when turn on the power, the legs will drop
gradually, with dripping sound at the same time. (If it was no reaction within two
minutes, then you can press this button again to turn it off). Press this button
again to stop it
