Stacking Rails
To protect G1 Mk II’s fine furniture grade cabinetry when stacking, stacking rails with felt coverings that
replace the metal feet are required. The kit contains all hardware necessary to attach the rails, as well as a
Speakon-to-Speakon high level jumper cables for daisy-chaining. Stacking G1 Mk II ‘s without these rails will
void the warranty.
Using the Remote Control to Address Multiple Sub-Bass Systems
The address selection is accessed on the remote control unit by removing the bottom aluminum cover in
the same way as outlined in the section Battery Installation. Removing the cover will reveal a small rotary
switch labeled “ADDRESS” next to the battery holder. Factory setting is position “0”. With the remote control
unit powered off (locked mode), this switch can be rotated using a small slotted screwdriver to select one of
sixteen possible address positions, “0” through “F”. Once a selection has been made, replace the back cover
and turn the remote control unit on (unlocked mode). At this point the remote control will not operate the
G1 Mk II. In order to pair the remote control unit with the sub-bass system, point the remote control unit’s
emitter at the LED display and hold the PHASE switch for 5 seconds. The LED under the CROSSOVER control
will flash once and the display on the Sub-Bass System will read “– – –” followed by a confirmation noting
the selected address. The Sub-Bass System is now paired with the specific remote control unit and will not
function with a different remote. In a system with multiple Sub-Bass Systems, change each address one unit
at a time with the Sub-Bass Systems not being changed switched-off to avoid inadvertently changing the
addresses of multiple units.
24
Summary of Contents for G1 Mk II
Page 1: ......
Page 2: ...Operating Instructions for the G1 Mk II Sub Bass System...
