12
LED Display
An LED display is located on the lower front of G1 Mk II. All functions that are user adjustable via the remote
control can be seen here. The display reverts to off a few seconds after adjustment.
Remote Control Battery Installation
G1 Mk II’s Remote Control Unit requires two AAA batteries. These are not installed but are supplied. To
install or replace batteries in the Remote Control Unit, first remove the bottom aluminum cover by using the
supplied 2.5mm Hex key to loosen the two visible screws. With the bottom cover removed, you will see a
battery holder, which will accept two AAA batteries. Follow the images on the holder for proper orientation
of the batteries. After installing the batteries, test the unit by setting the SECURITY switch to UNLOCK and
turning one of the knobs. If the batteries are installed properly, you will see one of the red LEDs on the
remote control’s front panel illuminate. Replace the bottom cover and tighten the two screws using the
supplied Hex key. Battery life can be extended if the SECURITY toggle switch is left in the LOCK position
when the Remote Control is not in use.
Remote Control Address Selection
The remote control unit provides an address selection function to allow multiple Sub-Bass Systems to be
used in an audio system with a separate remote control for each. Additionally, if the remote control of the
G1 Mk II interacts with any other piece of equipment in your system or if other remotes interact with your
G1 Mk II, the address can be changed to avoid unwanted interaction. See Using the Remote Control to
Address Multiple Sub-Bass Systems in the nest manual Section Connecting Up.
Summary of Contents for G1 Mk II
Page 1: ......
Page 2: ...Operating Instructions for the G1 Mk II Sub Bass System...
