Doc ID: 191-7913A
Doc Rev: 082018
Pg. 21
5. Use the wrench to turn the
adjuster screw
counterclockwise back to the
initial position, with the top
O-ring visible. Keep the fluid
topped off as you go.
6. Use your thumbs to compress the
piston again until it bottoms out while
looking for air bubbles.
When compressing the piston, fluid can shoot out from
the slave cylinder port. Be sure to wear eye protection.
7. Repeat steps 3 - 6 until there are no air bubbles coming
out in the fluid when the piston is compressed.
8. When the bleeding is complete, turn the adjuster screw
counterclockwise so that the top O-ring is visible.
9. Compress the piston until it bottoms out, and top off with
fluid.
10. Check that the ball bearing is still in place. Stand the
Rekluse slave cylinder in an upright position (so the fluid
does not spill) until it is needed in the next step.
