GB
3. Recognising and Removing Interferences
Display
Error cause
Remedy
No display
The device is not connected
to the mains.
f
Connect the included
mains adapter to the
ChronoDater and plug
the mains adapter into a
socket with the
matching mains voltage.
"Please wait"
The device performs set-
tings.
f
Wait until the device is
ready for operation.
"Batteries empty, please
change"
The batteries for saving your
settings are empty.
f
Have the batteries
replaced by trained
specialists.
"Insert Chipcard"
The Chipcard is not or incom-
pletely inserted.
f
Insert Chipcard.
"Card inserted incorrectly!
Turn over"
f
Turn over Chipcard.
"Please wait Printing"
Printing is difficult or
blocked.
f
If this message appears
frequently, contact your
specialist vendor.
"Warning 01"
The memory was overwritten
with default values.
f
Push [OK].
"Warning 15 to 17"
The Chipcard was not
inserted correctly.
f
Insert matching
Chipcard correctly.
"Warning 20"
"Warning 31"
The housing flap
2
is not
closed.
f
Close the housing flap
correctly.
Printing is interrupted.
Too-thick print media or
batch used.
In exceptions, the print roll
may block.
f
Disconnect the mains
adapter plug and tip
the device backwards.
You will see a knurled
wheel on the bottom.
Turn it until the block is
relieved.
43
ChronoDater 920/922/925
