Continued.
Using your 4mm Allen key remove the hex
screws from one side of the handle section.
You only need the screws from one side.
Put
these aside if you are reusing this handle.
Once removed you can slide the handle with
the Guide Pin out from the magnet case. Be
sure to remove the Guide Pin Bushes and
Teflon washers as well
.
If you are reusing
your handle put it to one side for use in
once the body has been replaced
At the rear of the magnet casing remove the
Cap head hex screws with your 6mm Allen
key. These are the last screws retaining the
magnet within the housing.
Using a long screw drive insert it into the
casing from the side to lever the magnet
from the case as it may be locked against the
demagnetising strip on the inside. Once free
remove the skirt from the surrounds of the
magnet pack. This will just slide off.
