42
While the function is running, it is possible to set a constant output of the ventilation unit (the
unit then ignores the time program and the alternation of comfort/setback modes).
Cooling function
The Cooling function can be switched on or off with the
ON/OFF
button.
In this section it is possible to enter the required cooling water temperature and set the cooling
parameters.
Cooling is determined by outdoor temperature
means that cooling to the ventilation unit
will only start if the outdoor temperature is above the set outdoor temperature for switching on
cooling. If the outdoor temperature falls below the outdoor temperature for switching on the
cooling, the cooling is deactivated again.
While this function is running, it is possible to set a constant output of the ventilation unit (the
unit then ignores the time program and the alternation of comfort/setback modes).
Only passive cooling from ground boreholes is possible with CTC heat pumps.
To activate the heat pump to cooling mode, it is necessary to turn on the option of
cooling by the heat pump in the heat pump menu.
4.6.9. Universal outputs
Information on universal functions (UNI function and UNI function 2). These functions are fully
configurable from the service interface. On the user level it is possible to display information
on temperatures and function outputs and to set the parameters of Thermostat 1 (thermostat
related to temperature 1), Thermostat 2 (thermostat related to temperature 2) and Timer.
4.6.10. RegulusRoute
Information about remote controller management is displayed in the RegulusRoute menu. You
will use this information to communicate with the service technician in case the controller is
unavailable through the RegulusRoute service for any reason.
4.7.
Menu with access to manuals (MANUALS)
In the Manuals menu you will find this manual and the manuals for the RCM and RCD room
units.
