Regency ULTRA, Owner'S Manual

Page: 44 / 85

VEHICLE OPERATION REGENCY ULTRA MOTORHOME
V e h i c l e O p e r a t i o n | 38
Retracting the Slide Out Room
Depress and hold the top of the slide out control
switch until the slide out room is fully retracted, then
release the switch.
Fully retract the slide out room to ensure the all-
weather seals are in correct alignment.
Servicing All-Weather Seals
Cracked or worn all-weather seals around the slide
out room may allow dirt and moisture to enter your
motorhome which could lead to premature interior
wear. Inspect the all-weather seals in the spring and
fall, and have them replaced if necessary.
Extensive travel and use in severe weather
conditions may cause more rapid deterioration of
some components, especially all-weather seals.
Have professional service personnel, adjust,
maintain, and replace the all-weather seals to extend
the life and comfort of your slide out room.
Slide Out Room Emergency Operation
If the slide out room fails to extend or retract
electrically, you can manually operate the slide out
mechanism. Manual operation of the slide out is not
recommended unless the slide out needs to be
retracted in order to move the motorhome.
•
Turn the main power off and disconnect shore
power if connected.
•
Locate the control module.
o
MB Models it is over the sink in the
bathroom in the outside wall.
o
TBS Models it is over the sink on the
passenger side right beside the entry
door
•
Unplug both motor electrical connectors from
the control module.
•
Remove the slide out Snap-On trim boards to
access the motor mounting screw on each side of
the slide out and remove the screw.
•
Peel back the exterior sweep gasket from the top
corners of the slide out and lift the slide out
motor to release.
•
Push in the slide out room until fully retraced,
keeping both sides of the slide out level with the
coach while retracting.
•
NOTE: Manual movement of the slide out
requires significant effort and may require the
assistance of several people.
o
Peel back the exterior sweep gasket from
the top corners of the slide out and re-
engage the slide out motor.
o
Replace the motor mounting screws on
each side of the slide out and replace the
slide out Snap-On trim boards.
o
Reconnect both electrical connectors to
the control module.
NOTICE
The slide out electrical function is protected by a
fuse located on the power distribution panel.
Check that the fuel is intact before resorting to
manual slide out operation.
CAUTION
Do NOT move the motorhome unless the slide
out room motors electrical connectors are
connected to the control module.
Reconnecting the motor electrical connectors to
the control module applies a brake to the slide
out room.