36
|
E33-10 FPI Direct Vent Gas Insert
|
36
maintenance
FAN MAINTENANCE
If your fan requires maintenance or replacement,
access to the fan is through the plate on the floor of
the firebox.
NOTE: the unit MUST NOT be operated
without the fan access panel securely in place.
Caution: Label all wires prior to
disconnecting when servicing controls.
Wiring errors can cause improper and
dangerous operation. Verify proper
operation after servicing.
DOOR GLASS
Your Regency stove is supplied with high
temperature, 5 mm Neoceram ceramic glass that
will withstand the highest heat that your unit will
produce. Do not abuse the glass by striking the
surface or by slamming the door shut.
If your glass requires cleaning, we recommend using
an approved glass cleaner available at all authorized
dealers.
Do not use abrasive materials. Do not
clean the glass when hot.
In the event that you break your glass by impact,
purchase your replacement from an authorized
Regency dealer only, do not use substitute materials.
Follow our step-by-step instructions for replacement.
Warning: Wear gloves when removing damaged
or broken glass.
Caution: Do not operate appliance with
glass panels removed, cracked or broken.
Replacement of the glass should be done by a
licensed or qualified service person.
Flush Glass Replacement
Remove the flush door front (refer to the "Standard
Flush Door" section). Remove the 4 glass clips from
each corner. Slide in the new replacement glass.
Push the 4 glass clips back onto the frame.
To Remove Fan:
1)
Turn the unit off and allow it to cool down to
room temperature.
2)
Unplug or disconnect power source to stove.
3)
Remove the safety screen and glass door, see
instructions in manual.
4)
Remove logs and grate -see manual for details.
5)
Remove optional brick panel set, if installed
(refer to the "Optional Brick Panel" section).
When removing side brick panels the two screws
that hold the grate down must be removed first.
Straighten adjustment wire.
Air Shutter Wire
8)
Remove the rear log support by unscrewing
the 2 screws.
7)
Remove the Burner by removing the 2 screws
(1 on burner bracket and one on valve tray). Tilt
the burner up and slide to the left away from the
orifice.
9)
Remove the 12 screws holding the Access
Panel in place.
10)
Unplug the wires from the fan motor (from inside
the stove).
6)
Straighten the adjustment wire under the firebox
base.
Screws
Fan Access Plate Screws
11)
Remove the 2 screws from the fan
bracket.
Screws
Screws
Screws
