11
Regency I31-3 Gas Fireplace Inbuilt
BAY FRONT
INSTALLATION
1)
Place the bay door onto the 2 pins on the
top of the unit.
2)
Install bottom louvre by sliding the two
bracket clips into the brackets located
underneath the bay door and secure with
2 screws into the bracket on the bottom of
the Bay Front as per diagram above.
3)
Slide the valve extension knobs onto the
valve knobs. match the correct ext. knob
with the valve knob.
BAY LOUVRES
1)
Install top louvre by sliding the two bracket
clips into the brackets located on top of the
bay door. See below. The fi tted louvre leaves
a small gap between faceplate bottom and
louvre top.
INSTALLATION
FLUSH LOUVRES
1)
The top louvre is held in place by friction fi t,
if the louvre needs to be adjusted; bend the
bracket out as shown in the diagram.
3) Place the bottom of the fl ush glass behind
the bottom glass trim.
4) Secure the glass with the two glass clips at
the top corners of the glass. Secure glass
clips with the screws provided. Do not over
tighten as this could break the glass.
5) Slide in the top glass trim under the spring
clips.
2)
Position 2 magnets on the back of each trim
piece close to the ends. Place the top and
bottom trim pieces on the bay front.
3)
Install top and bottom louvres.
Note: The top and
bottom trim pieces
are different, check
diagrams above and
below.
6) Install safety screen (only in Australia) by
inserting the 4 brackets into the 4 slots.
Note: Optional safety screen only in
Australia.
Note: Top and bottom louvres and brackets
are different.
2)
The bottom louvre has a hinge that is at-
tached (2 screws per hinge) to the lip on
bottom of the unit.
