30 | Regency U31-10 Gas Fireplace Insert
|
30
installation
LOW PROFILE FACEPLATE INSTALLATION
1
02/16/15
919-524
U31
1)
Attach the inner faceplate panel to the insert body using 4 screws
in the locations shown below.
Diagram 1
Diagram 2
Diagram 3
Diagram 4
LOW PROFILE FACEPLATE INSTALLATION
2)
Connect the male end black and red fan switch wires to the wire
connectors from the fan speed control.
Diagram 5
Diagram 6
3)
Tuck the wires into the clip to keep them away from the insert using
the clip provided. Attach the clip to the rear of the faceplate to en-
sure that the wires do not touch the side of the unit. The power cord
should be run behind the inner faceplate panel.
4)
Install the on /off switch - fan speed control box to the left hand
bottom leg of the inner faceplate. Controls located on the left side.
5)
Feed wires through the left air chamber clip - then clip it to lower
left of fi rebox as show below.
Wire
feed
6)
Clip the right side air chamber clip as shown below in Diagram 7.
Diagram 7
