Regency Fireplace Products Cascades I1500, Owners & Installation Manual

Page: 31 / 48

I1500 Regency Wood Insert
|
31
31
|
installation
920-051b 03.24.20
2
Square Catalyst
Support
2. Slide bypass rod through the horizontal open-
ing above the door. As you slide the bypass rod
in ensure it engages into the opening of the
cartridge. Once penetrated, take your clip and
install it from the inside of the cartridge. Move the
bypass rod in and out to ensure the cartridge is
moving and by pass rod is secured.
Diagram 2
Insert Rod into
Horizontal
Opening
Diagram 3
Insert Rod into
Cartridge
Diagram 4
Diagram 5
Remove clip through
inside of the car-
tridge and hook onto
bypass rod
3. Take your round catalyst and install it into the
square support. Then take the catalyst and
square support and insert it into the cartridge
in the unit. Take the flame shield and slide back
end into the opening. Then take retainer and slide
into position securing the flame shield. Tighten
the two 7/16” bolts. You have now completed
the install of the catalyst, bypass rod and flue
adaptor.
Diagram 14
Catalyst in square
support
Install square support and
catalyst into cartridge
Install flame shield into rear flange
and reinstall locking clip removed in
Step 1
4. Now proceed with faceplate installation instruc-
tions. Re-install door/ bricks and install tubes and
baffles. Also feed the probe wire to the left hand
front of the appliance. This will make it easier to
hook the monitor when installing the faceplate.
NOTE: If your cavity height is tall enough, you
can install the adaptor onto the unit first and then
connect to the liner.
NOTE: when cleaning chimney, remove tubes,
baffles, retainer, flame shield and catalyst. After
sweeping re-install.
1. Remove locking clip from the front face of the
Catalyst assembly by sliding up and out.
BYPASS ROD REMOVAL /
INSTALLATION
Diagram 1
Diagram 6
Diagram 7
Diagram 8
Bypass Rod
Removal/Replacement