STEP 1
STEP 2
STEP 3
BASE LOCK
Reinstall your gate in the doorway or opening
according to the instructions, using the newly
installed wall cups as anchoring points for
the (4) threaded spindle rods.
Operating the Door Latch
With the gate fully removed, you can now use the
circles you marked during Step 1 as guides for
screwing in your (4) wall cups (D). Center each of
the wall cups within the guide circles and use the
provided self-tapping 25mm screws (E) to fasten
them in place via the hole through the center of
each wall cup.
Next, completely remove the gate from the
opening by loosening each of the (4) threaded
spindle rods to depressurize the gate.
After you have mounted your gate, and you are
satisfied with its positioning, draw a circle on
the surface of your doorway or opening around
the perimeter of the (4) rubber feet.
Positioning and Attaching Wall Cups
STEP 1
NOTE:
If your secure lift latch is not properly engaging with the
receiving component, ensure that your gate is level, mounted properly,
and that you have not over-tightened the threaded spindle rods.
STEP 2
At the bottom of the gate door, rotate the base lock to the horizontal
position to allow the door to swing open.
NOTE:
Place lock down on side occupied by the child.
Pull the spring lock away from the secure lift latch while
simultaneously lifting the lock lever upwards. This will release the
locking latch from the gate frame and allow the door to push or pull
open. To lock the door shut, close the door completely, then push down
on the lock lever to re-engage the spring lock.
LOCK LEVER
SPRING LOCK
