Reflexion HIF1897T, Manual

Page: 30 / 39

EN
30
PHONO MODE
Preparation
1. Open the PROTECTIVE LID (1) of the device.
2. Screw the TRANSPORT SCREW (50) all the way in with a small
screwdriver. Remove the pin protection from the TONEARM CLAMP (22).
NOTE:

Do not manually rotate or stop the PLATE (36) . It can cause damage.
Transport or vibration without the tonearm being secured with the
TONEARM CLAMP (22) could damage the tonearm.
IMPORTANT:

To protect the turntable from damage during transport, there is a
silver transport screw on the right above the turntable. Before
starting playback, turn the screw all the way in with a
screwdriver.
Play vinyl record
1. Press the PHONO button (31) to switch to "Record" mode.
2. Place a record on the PLATTER (36) .
3. If you want to play a 17cm single place the SINGLE-ADAPTER (23) on the
TURNTABLE (36) before you put on the recorder.
4. Set the SPEED SELECTION SWITCH (24) to 33/45 or 78 rpm, depending
on the record.
5. Unlock the TONE ARM CLAMP (22) and remove the protective cap from the
tone needle.
6. Lift the tone arm with the TONE ARM LEVER (16) .
7. Move the tonearm to the beginning of the record or a specific track.
8. Carefully lower the tone arm with the TONE ARM LEVER (16) onto the
record to start playback.
9. If you want to stop the record during playback, lift the tonearm off the record
and swing it back to the
TONEARM SUPPORT (25) .