6. Pump Trouble Warning
Indicator Lights
1.Humidity Display Screen
1. When the unit is powered on, it shows the indoor humidity.
2. While setting the desired humidity level, the screen will show the set humidity. After a brief delay,
the display will revert to indoor humidity level.
2. Power Indicator Light
This light indicates that the unit is properly powered on and ready to perate. Always make sure the unit is “off”
prior to performing any service.
3. Continuous Mode/AutoDefrost Light
4. Compressor Light
When the compressor light glows red, it indicates the compressor has been initiated but is currently warming up.
Once the compressor light switches to green, it indicates the compressor is in working status.
5. Unit Indicator Light
When the unit indicator light is red, it illustrates the dehumidifier is in unit mode.
While in unit mode, the dehumidifier will use it’s built-in humidity sensor. If using a remote control, unit mode will
allow you to remotely monitor the room conditions where the dehumidifier is located.
6. Remote Indicator Light
When the pump reservoir water level is too high, the high water sensor will activate to prevent over-flow. When
this occurs, the dehumidifier will stop the compressor automatically and the display willshow “E4”. After a 1
minute delay, the fan motor will turn off and the machine will not operate until the problem is resolved. To reset
the unit after an “E4” error, check the pump to verify it is functioning,
then unplug the unit for two minutes.
The display screen has two functions:
When this light illuminates green, it indicates that the dehumidifier is set to continuous operation mode.
When the light glows red, it means the unit is in auto defrost mode and clearing the evaporator coil of any ice buildup.
When the remote indicator light is red, it illustrates the unit is remote mode.
While in remote mode, the dehumidifier will use the sensor on the remote control unit. In this mode,the inlet and
outlet of the dehumidifier can be ducted.
88
power
Cont.
Defrest
Comp
Unit
5
