9
the100-240VAC power supply. Then connect the output plug of the adapter to the input plug of the pedestal,
and then the indicator turn to white (the MaxCure5 indicator turn to green), that means the pedestal is
standby. Put the main unit to the charging point of the pedestal, the indicator turn to blue (the MaxCure5
indicator turn to yellow) , and the curing lights starts charging. When charging finished the indicator turn to
white (the MaxCure5 indicator turn to green).
3.2 Installation of the built-in models
a) Connect the Curing Light power supply line with the power (24VAC) of dental unit. Tight the nylon thread
to the fixation of the dental unit, then it will be available for operation.
Notice:When installing the Curing Light, be sure the power is cut off. The two power wire should be
a little longer than the nylon thread to keep the power wire safe.
b) Take off the red cap from the optical fiber and insert the metal part into the front of the built-in Curing Light
(Make sure to screw the fiber to the end by rotation).
c) Install the light hood as showed in picture 1.
d) Uninstall the Curing Light, just reverse the procedure above.
4 Operation
4.1 Modes setting: Lightly press the mode key to change the running modes. The Curing Light will shine the
diffrent Illuminated blue light.The available modes see the
Technical Parameters table
.
4.2 Time setting: Lightly press the time button to choose the solidification time. The available time setting
see the
Technical Parameters table.
4.3 During the operation, aim blue light at the position needing solidification. Press the power button "ON/
OFF" switch, a "beep" sound will appear, the Curing Light starts to work under the selected mode. Then it
