9
2.2 ACCESSORIES INSTALLATION
Inspect the box for damage and report any to the transport carrier and the distributor. Do not proceed
with assembly and set-up if the box is damaged. Keep the original box and packaging to ensure safe
future transport of the device. When bringing the device from a cold environment into a warm one, do
not plug it into the power source until the device has had time to equilibrate to room temperature
(Minimum 2 hours).
Unpack the device and place it on a stable horizontal surface. Always position the device out of direct
sunlight. Please note, the control unit heats when in use. The device must not be positioned near other
heat sources. Allow a minimum of 4 inches (10cm) clearance behind the rear panel. Do not place the
device on any soft surface (such as a towel), which may obstruct air flow to the bottom cooling vents. Do
not put any heat-producing devices or any objects containing water or other liquids on the device. Do
not place the device close to appliances producing strong electromagnetic, electrical or magnetic fields
(diathermy, X-rays, etc.), this could damage the device and negatively affect the appliance.
Procedure:
1. Install all components. Plug the applicators into the back panel sockets.
2. Connect the device to the supplied power adapter. Plug the device directly into the socket by aligning
the red dots. Do not use any multi-connection extension cables or two-socket adaptors.
3. Connect the applicators to the connector on the back panel as follows:
Turn the applicator so that the red dot is in line with the red dot on the output connector. Plug the
connector in. When disconnecting the connector, take the indented part of the applicator connector and
pull slowly towards you, to disconnect carefully.
CAUTION
DO NOT USE FORCE TO CONNECT, IF FORCE IS APPLIED THERE IS A RISK OF DAMAGE TO THE DEVICE.
