SAFETY INSTRUCTIONS
The Combi Condensate pump is to be installed in accordance with
local and regional electrical codes.
Save these instructions for further reference.
The following symbols related to safety are used on the product or
throughout the product documentation
WARNING/CAUTION
An appropriate safety instruction should be
followed or caution to a potential hazard exists.
DANGEROUS VOLTAGE
To indicate hazards arising from dangerous voltages.
WARNING: Please read all safety instructions and the installation
instructions completely before commencing.
To prevent any risk only certified and appropriately trained staff with
sufficient technical training and tools shall install this product.
Product installation and electrical connections both require
professional training for safe installation and correct product operation.
WARNING:
Disconnect all electrical power before starting installation,
maintenance, or service work.
WARNING: Disconnect electrical power before removing and checking
internal fuse.
CAUTION: This pump is not submersible and for indoor use and
connection only.
CAUTION: Do not install The REFCO condensate pump if there are
any signs of damage.
WARNING: Check the cables of the REFCO condensate pump power
and alarm cords prior to, during and periodically for signs of damage. If
either the power or alarm cords are damaged, isolate and disconnect
the condensate pump from service. Contact REFCO for a replacement.
** The Combi combined power/alarm cable lead-out is non-replaceable.
lf this is damaged the entire pump must be replaced.
WARNING: The REFCO condensate pump cables should not be cut,
and should be routed so that they cannot be damaged during and after
installation.
CAUTION: All tubing connections are to be secured in place on the
barb connections using self-locking cable tie-wraps.
DO NOT use tools to connect the tubing.
DO NOT operate this product in ambient temperatures below 41 °F
(5 °C).
DO NOT operate with incoming water above a temperature of 104 °F
(40 °C).
CAUTION: Do not allow any chemicals to come in contact with this
condensate pump. Please remove the pump and water sensor before
using any coil cleaning solutions and other chemicals. Flush the
evaporator coils with water before re-installing the condensate pump
and water sensor.
Ensure the coils are chemical free before reinstallation.
WARNING: If the Combi pump is to be installed within a
duct, air handling space or plenum it must be installed
within an appropriately rated fire and smoke proof
enclosure.
Technical specification Combi
Power rating:
100 - 240V, 50-60 Hz, 8W
Alarm relay:
Rated 250V, 10A Max or 28VDC, 10AMax
Minimum flow rate:
11 GPH
(
42 l/hr.)
Maximum suction:
9.80 ft. (3.0 m)
Maximum head:
65.60 ft. (20.0 m)
Maximum horizontal run:
330 ft. (100 m) at 0 head and 0 suction
Sound:
19dBA at 1 m DIN EN ISO 3741:2011 / DIN EN ISO 3744:2010
Discharge star tube:
1/4“ (6.25 mm) ID, 3.3 ft. (1m) in length
Overall dimensions:
9.84 × 11.81 × 2.1 inches (250 × 340 × 54 mm)
Bulk pack:
10 Pcs dimensions are 23.2 × 10.4 × 14.4 inches (590 × 265 × 365 mm)
Color:
RAL #7040 grey and RAL #1023 yellow
Protection:
Fully potted, IP-44
Weight:
0.63 lbs. (285 g)
Operating temperature:
Ambient & water 41-104°F (5-40°C)
Compliance:
Conforms to UL: 778 and Certified to CSA C22.2 #68
2
www.condensate-pumps.com / Combi Manual
July/Juillet 2019
BVM02520200217
