TMA2Q/LPC2Q Quadrature Tower Mounted Amplifier Instruction Manual
Refer to last page for revision and copyright information, File: TMA2QInstructionManual.doc, Page 11
The frequency file usually is setup using the Frequency Genie software tool and then edited if necessary for the
specific installation. After the frequency file has been generated and placed in the proper folder, it is referenced
in
callisto.cfg
by assigning the frequency file name to the parameter
[frqfile]
.
An example of
callisto.cfg
parameters is shown below with // indicating the affected parameters. Refer to the
Callisto Software Setup Guide for parameter definitions and other requirements for the configuration file.
[rxcomport]=COM1
[observatory]=12
[instrument]=MY_INST
[titlecomment]=MY_RO
[origin]=NA
[longitude]=W,100.0
[latitude]=N,50.0
[height]=0.0
[clocksource]=1
[filetime]=900
[frqfile]=frq50500.cfg
// user prepared frequency file
[focuscode]=59
[mmode]=3
[fitsenable]=1
[datapath]=c:\Callisto\Data\
[logpath]=c:\Callisto\Log\
[lcpath]=c:\Callisto\Lc\
[ovspath]=c:\Callisto\OVS\
[chargepump]=1
[agclevel]=120
// PWM level for gain, range 50...255, default 120
[detector_sens]=25.4
[db_scale]=5
[autostart]=0
[priority]=2
An example frequency file with nominal 50...500 MHz range is shown below, but it shows only the first ten and
last five frequencies in the list of 200 channels. Refer to the Callisto Software Setup Guide for parameter
definitions and other requirements for the frequency file.
[target]=CALLISTO
[on_line_testpoint_number]=100
[number_of_measurements_per_sweep]=200
[number_of_sweeps_per_second]=4
[external_lo]=0.000000
[0001]=0050.000,0
[0002]=0050.000,0
[0003]=0050.000,0
[0004]=0050.000,0
[0005]=0050.000,0
[0006]=0050.000,0
[0007]=0050.000,0
[0008]=0050.000,0
[0009]=0052.313,0
[0010]=0054.688,0
...
...
[0196]=0496.438,0
[0197]=0498.813,0
[0198]=0501.188,0
[0199]=0503.563,0
[0200]=0505.938,0
