26
7. Assembly
a) Drone
1 Insert the board into the base plate from above. Please pay attention to the correcta-
lignment. The components should insert easily and should not twist. When the base
plate is correctly aligned, the two battery loops point downwards. The four connectors
for the motors also point downwards to the base plate and are guided through the re-
cess on the arms. The infrared LED on the base of the board can only be guided into
the mounting in the base plate in one position. If the parts cannot be inserted, turn the
parts to one another in a different position.
2 Clip the cover cap to the base plate. Note the position of the LED and battery connec-
tion. The board should no longer be visible from above.
3 Select the respective motors for the correct mounting. These are also marked on the
base plate with A/B. The corresponding connectors are colour coded and fit the con-
nection on the board in each case. There is no mechanical reverse-polarity protection.
Plug the motor wires with connection through the elongated hole directly to the motor
mounting.
4 Insert the motors into the mountings in each case. Guide the cables through the slots
on the side. When fully installed, the motors protrude approx. 4 mm. Do not try to push
them further into the housing.
5 Connect the motor plug to the in-built board in each case. Guide the non-fixed cable
sections under the hook along the axes.
