reedinstruments
www
com
8
5..Press.the.MODE.button..The.measurement.mode.will.change.between.
AC.or.DC.as.required.
6..Remove.power.from.the.circuit.under.test,.then.open.up.the.circuit.at.
the.point.where.you.wish.to.measure.current.
7..Touch.the.black.test.probe.tip.to.the.negative.side.of.the.circuit..And.
touch.the.red.test.probe.tip.to.the.positive.side.of.the.circuit.
8..Apply.power.to.the.circuit.
9...Read.the.current.in.the.display..The.display.will.indicate.the.proper.
decimal.point,.value.and.symbol.
Resistance [ Ω ] Measurement
WaRninG:
To.avoid.electric.shock,.disconnect.power.to.the.unit.under.test.
and.discharge.all.capacitors.before.taking.any.resistance.mea-
surements..Remove.the.batteries.and.unplug.the.line.cords.
1..Set.the.function.switch.to.the.
Ω
.position.
2..Insert.the.black.test.lead.plug.into.the.negative.(COM).socket.and.the.
red.test.lead.plug.into.the.positive.
Ω
.jack.
3..Press.the.MODE.button.until.“
Ω
”.appears.in.the.display.
4..Touch.the.test.probe.tips.across.the.circuit.or.part.under.test..It.is.best.
to.disconnect.one.side.of.the.part.under.test.so.the.rest.of.the.circuit.
will.not.interfere.with.the.resistance.reading.
5..Read.the.resistance.in.the.display..The.display.will.indicate.the.proper.
decimal.point,.value.and.symbol.
Continuity Check
WaRninG:
.To.avoid.electric.shock,.never.measure.continuity.on.circuits.
or.wires.that.have.voltage.on.them.
1..Set.the.range.switch.to.the.
.position.
2..Insert.the.black.lead.plug.into.the.COM.socket.and.the.red.test.lead.
plug.into.the.positive.
.socket.
3..Press.the.MODE.button.until.“.
.”.appears.in.the.display.
4..Touch.the.test.probe.tips.to.the.circuit.or.wire.you.wish.to.check..
5. If the resistance is less than 35Ω, the audible signal will sound.
.
The.display.will.also.show.the.actual.resistance.in.ohms.
