reedinstruments
www
com
9
b) When connected as shown in Fig. 2, a reverse check on the
diode is made. If the diode under test is good a 1 will show on the
display. If the diode under test is defective, .000 or other numbers
will be displayed. Proper diode testing should include both steps
a and b.
AC Current Measurement (Clamp-on)
Move the function rotary switch to the 2000A position and press the
function button till the display shows
. Press the trigger to open the
current sensor jaws and clamp it around the measuring conductor only
DC Current Measurement (Clamp-on)
Move the function rotary switch to the 2000A position and press the
function button until the display shows
. Push the DCA Zero button for
at least 2 seconds to display a value of zero. Press the trigger to open the
current sensor jaws and clamp it around the measuring conductor only
Note: It is recommended to use the auto range mode during
measurements. If you press the range button during auto range mode the
meter will hold the range. For your safety please insert the terminal rubber
cover (Fig. 3) for protection.
Fig.1
Fig.2
Fig.3