REED 1H, User Manual

Page: 3 / 8

Figure 4
f) Insert armtube [7] into a frame [4]
Needles of the bearings [7a] and [7b]
must be embed in sapphire V cup
( Figure 4 ).
Figure 5
g) Set an armtube with frame [4] on a
bottom bearing [4b] in tonearm body
[6].
Needle of the bearing [4b] must be
embed in sapphire V cup ( Figure 5 ).
Figure 6
h) Screw out the top bearing [4a] ( Figure
3 , 6) from bearing protection [4c]. Take
the hex (allen) key [3a] ( Figure 6 ) from
accessories [3] ( Figure 3).
i) Srew in a top bearing [4a]. Needle of
the bearing must be embed in sapphire
V cup
. Bearing should be screwed in
tight, however do not apply excessive
force. Check if both axis bearings [4a],
[4b] (
Figure 5, 6 ) and [7a], [7b] ( Figure
4) are in correct positions.