MILLI
CUBE HEATED TOWEL RAIL
1025 X 850
MILLI Aust v1.1
INSTALLATION OF MILLI LADDER TOWEL WARMER
This Package Contains:
1 Ladder Towel Warmer and flex
4 Mounting Feet with Mounting Barrel & Grub Screw
(with 2 pin plug Australian models only)
4 Mounting Screws to fix Brass mounting Barrel to wall
1 Brass Concealed adaptor (optional)
3 Fixing screws to attach feet to towel warmer
CAUTION:
Prior to installation please ensure the product is to your satisfaction. This product is not intended for use by young
children or infirmed persons without supervision. Young children should be supervised to ensure they do not play with the product.
To minimize a hazard for young children, this appliance should be installed so that the bottom rail is 600mm above the floor. The
supply cord cannot be replaced. If the cord is damaged the appliance should be scrapped or contact the supplier.
Installation:
This towel warmer should be installed by a registered electrician and in accordance with local and national electrical codes. We
recommend that the towel warmer be installed vertically on a flat and uniform wall, and where possible into studs or other suitable
anchor material. If fixing to hollow cavity walls, Toggle Anchors or similar devices must be used.
Position the towel warmer so that the plug and mains power receptacle are easily accessible, with the cable entry to the towel
warmer NEAREST THE FLOOR. Avoid the supply cable coming into contact with the heated parts of the towel warmer.
DO NOT PLUG THE UNIT INTO THE POWER SUPPLY OR SWITCH THE TOWEL WARMER ON BEFORE INSTALLATION IS
COMPLETE.
1
If the warmer is being installed without using the concealed adaptor proceed to no2. If the towel warmer is being
installed with a concealed wiring adaptor, proceed to that section.
2
Remove the 4 mounting barrels from the 4 stainless steel feet then attach the 4 stainless steel mounting legs to the
towel warmer
3
Hold the towel warmer in position and mark around one of the top legs. Remove the towel warmer and fix the mounting
barrel to the wall.
4
Place the leg onto the mounting barrel and, making sure that the towel warmer is level, mark the location of the
remaining top leg. Fix the mounting barrel to the wall
5
Place the towel warmer onto the two mounting barrel’s and mark the location of the two bottom legs.
6
Remove the towel warmer and fix the remaining two mounting barrels to the wall
7
Place the towel warmer in position and secure it to the mounting barrels using the 4 grub screws.
