MILLI
CUBE HEATED TOWEL RAIL
1025 X 850
MILLI Aust v1.1
MILLI LADDER TOWEL WARMER
SPECIFICATIONS:
Recommended use
Domestic, hotel and
commercial
Colour Availability
Polished Stainless Steel
IP Rating
IP45
Warranty (see below)
3 years
Standards
AS/NZS 60335
WARANTY & CARE DETAILS:
Dear Customer,
This is the warranty by Reece Pty Ltd. relating to this product. Please keep it together with your
purchase receipt. In the unlikely event of a query please contact your nearest Reece Plumbing
Centre.
Care and Cleaning
The polished stainless steel finish of your towel warmer is hard wearing and easily maintained.
Clean with a soft cloth and non-abrasive cleaning agent.
Guarantee
This product is guaranteed against defects due to faulty workmanship or materials for 3 years
from date of purchase. In the event of a defect in the product, it should be returned with the sales
receipt to the retailer from whom it was purchased. Under the guarantee the defective article will
be repaired or replaced at the manufacturers option – free of charge. Costs of disconnection,
reconnection, and freight are the responsibility of the owner, as is any damage arising in transit to
and from servicing.
This guarantee does not cover:
a. Any damage to the product caused by misuse, neglect, accident, or in violation of the
manufacturer’s instructions, or
b. Any damage, loss or injury arising as a consequence of the use of the product.
Operation
Your MILLI Towel Warmer uses only minimal electrical power - about the same as an average
light bulb. It will take approximately 20-30 minutes to reach maximum operating temperature.
MILLI Towel warmers are designed for continuous operation. NOTE: The temperature of your
towel warmer will vary with the ambient temperature of your room. A towel warmer is designed to
warm and assist the drying of towels and will normally operate at a temperature that is too hot for
the warmer to be grasped for an extended time.
Locating Instructions
The MILLI Ladder Towel Warmer should be fixed through the wall cladding directly to studs or
other suitable anchor material. The towel warmer should be located in compliance with the
AS/NZS 60335 Standard and should not in any circumstances be located in the direct path of a
water source (tap or shower etc). MILLI towel warmers have an IP45 rating offering you the
greatest flexibility to safely locate the towel warmer in bathrooms or shower rooms.
Electrical Installation
Please ensure your towel warmer is installed by a registered electrician and ensure the electrical
supply, plug & switch location, and product location will comply with your local regulations.
This appliance must be fitted with an air gap phase isolation switch. For complete temperature
control a wall mounted dimmer switch (with “off” position) is recommended.
Concealed Wiring Kit
A concealed wiring adapter is included with this product. If you have access to the wall cavity the
kit allows you to conceal the electrical flex for a more streamlined and visually appealing
installation. Concealed wiring fittings must be installed before the wall cladding is installed.
