REDT Miracle-A6, Instruction Manual

Page: 35 / 83

- 34 - MIRACLE-A6
◈
Distance measurement between Decoder and Cutter
- Be sure to measure the distance between Decoder and Cutter before setting up the origin of the
clamp.
1. Press and hold menu button for five seconds.
2. From the screen above, press key to choose [3.Tool Calib.] and press [Enter].
3. 1. After installing the Automobile Key Clamp, install the center measure bar on the top of the Clamp
and Press the [Enter] button.
4. After finishing the measurement of Decoder, replace the Cutter with Decoder according to the screen
below and press [Enter].
☞
TIP)

Since the distance between Decoder and Cutter
is already measured at the factory, it doesn’t have to
be measured again.

If the distance between the Decoder and Cutter is measured again, the origins of all clamps should be
measured again.
Clamp Origin setting
Replace