Page 9
WyzBee™
User Manual
Version 1.2
WyzBee™
User Manual
Version 1.2
2
Setting up WyzBee™
2.1
Setup Requirements
Setting up and working with WyzBee™ is easy. Before you start, make sure you have the
following hardware and software components:
Hardware:
The WyzBee™ baseboard
32/64-bit PC with minimum 2GB RAM and USB Port for Power, Downloading and
Debugging
Software:
Windows 7/8/8.1 Operating System.
The CMSIS-DAP driver provided by Spansion. You can download the driver from
https://www.spansion.com/Support/microcontrollers/developmentenvironment/
Pages/board-SK-FM4-U120-9B560.aspx
. More details are given in
Section 2.2
.
An IDE like Keil uVision, IAR Embedded Workbench or CooCox CoIDE.
2.2
Installing the CMSIS-DAP Drivers
Follow the steps below to download and install the CMSIS-DAP Drivers.
1)
Download the complete set of drivers and tools from the following link:
(USB drivers for virtual COM port and CMSIS-DAP)
https://www.spansion.com/Support/microcontrollers/developmentenvironment/Page
s/board-SK-FM4-U120-9B560.aspx
Note:
If the device gets detected as an unknown device, update the drivers from the device
manager and point to the location of the newly downloaded drivers.
2)
Windows USB drivers that are specific to WyzBee™ need to be installed for the
detection of debugging port. In the downloaded folder, navigate to the “drivers” folder
and double-click on the driverinstaller.exe file. The window below will appear.
Figure 4: CMSID-DAP Drivers Installation Window
