Redmond RTP-805, Manual

Page: 11 / 16

RTP-805
11
ENG
UKR
KAZ
Manual water supply
1. Place a cup under the thermopot spout.
2. Press the button to unlock water supply; the button indi-
cator will light up.
3. Press and hold the “ НАЛИТЬ” button until your cup is full.
4. 10 seconds after the water supply is finished, the lock will
turn on automatically, the indicator of the button will turn
off.
5. To lock water supply manually (before it turns on automati-
cally), press the button; an audible signal will sound, the
button indicator will turn off.
Automatic water supply
1. Place a cup under the thermopot spout.
2. Press the button to unlock water supply; the button indi-
cator will light up.
3. Press the (approx. 150 ml) or (approx. 250 ml) button,
the water supply process will start.
4. The water supply will stop when the programmed volume is
reached.
5. To interrupt water supply, press the or button again.
Automatic water supply can also be interrupted by pressing the
, “ НАЛИТЬ” or button.
Changing the program setting
You can adjust the volume of the automatic water supply and save
your own settings instead of the factory settings. To do this:
1. Press the button to unlock water supply; the button indi-
cator will light up.
2. Press the or button, the water supply process will start.
3. Release the button when the desired volume is reached
The next time you start the adjusted program, the water supply
process will automatically stop after reaching the volume you
have set.
You can also restore factory settings. To do this:
1. When the water supply system is locked (the button indica-
tor is off), press and hold the button until you hear a beep.
2. The appliance will return to operation with the factory set-
tings.
Water cooling mode
The mode is recommended for accelerated cooling of water to
the required temperature.
1. Press the button, the button indicator will start flashing.
2. Use the and buttons to set the desired water tempera-
ture (in the range of 45–90 °C, in 5°C increments).
3. Do not press the control panel buttons until five short beeps
sound; the water cooling process starts.
4. During the mode operation, instead of the digital indicator
of the current temperature, will be displayed; the
button indicator will be constantly lit.
5. To stop the water cooling mode, press the button; the
button indicator will turn off. Pressing the button again
restarts the cooling process to the set temperature.