Operation
To start the product with a cold engine
1. Run the basic product warm and then shut down the
product.
2. Mount the attachment as per the assembly
instructions.
3. When adjusting the carburettor, make sure that the
dethatcher is held against the ground and that no
one else is in the vicinity.
4. Keep the moss dethatcher idling.
5. Make sure that the handle and safety features are in
good working order. Never use a product that lacks a
part or has been modified outside its specifications.
To use the attachment
1. Run the moss dethatcher at full gas (or nearly full
gas) with the wheels resting on the surface.
Note: It is both tiring and unnecessary to lift or hold
the moss dethatcher above the surface when
working.
2. Keep an acute working angle to the surface. With a
large working angle, the moss dethatcher tends to
move towards you and you risk losing control of the
product.
Maintenance
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
To perform maintenance on the
attachment
CAUTION:
Much work on the moss dethatcher is often
done in dusty conditions. It is extremely
important the air filter is inspected regularly,
often daily, and oiled in order to work
satisfactorily.
Refer to the product’s operator’s manual for
maintenance instructions.
WARNING: The gear housing gets hot when
the product has been in use. To avoid
burning yourself do not touch the gear
housing.
1. Check that the moss dethatcher does not rotate
when idling.
2. Clean the wheels if not rotating freely.
Transportation, storage and disposal
Transport and storage
If transporting the attachment on another vehicle always
use approved securing devices and make sure that the
attachment is securely held.
Ensure the attachment is cleaned and that a complete
service is carried out before long-term storage.
8
411 - 003 - 23.01.2020
Summary of Contents for 590684801
Page 26: ...26 411 003 23 01 2020 ...
Page 27: ...411 003 23 01 2020 27 ...
