29
5.1.7 Restart
When the control system requires a reboot; for example, after a module
re-configuration, this symbol will be flashed.
5.1.8 Fault
The control system can detect a wide variety of errors. When the system has detected an
error that is not severe enough to cause the system to trip, then this symbol will be
displayed.
5.1.9
Motor Temperature
This symbol is displayed when the control system has intentionally reduced the power
to the motors, in order to protect them against heat damage.
5.1.10
Control System Temperature
This symbol is displayed when the control system has intentionally reduced its
own power, in order to protect itself against heat damage.
5.1.11
Timer
This symbol is displayed when the control system is changing between different
states. An example would be entering into Programming Mode. The symbol is
animated to show the sands falling.
5.1.12
E-Stop
If the control system is programmed for latched drive or actuator operation, then it is
normal for an Emergency Stop Switch to be connected into the External Profile
Switch Jack.
If the Emergency Stop Switch is operated or disconnected, this symbol will be
displayed.
5.1.13
Bluetooth
When Bluetooth Mode is entered the screen will display the following icon.
