Assembly instructions
The Junior Rider enables you to transport your second child comfortably and quickly when they are feeling
tired. It can be attached to the axle, rear bar or folding plate of most of prams, strollers and buggies.
IMPORTANT
• The Junior Rider is built for children aged upwards of 15 months and with a body weight of up to 20 kg.
• The Junior Rider is developed for prams, strollers and folding buggies with a rigid rear axle or tube with a
diameter of up to 45mm. It may not be suitable for some models without applicable rear construction or in
cases where the brake function is hindered.
A. Secure the wheels (2) to the foot-board (1) with the bolts (3) and nuts (4). Ensure that the nuts
are firmly tightened. Use the universal tool included for this and further steps.
B. The coupling part (6) of the Junior Rider can be assembled using one of 3 pairs of adaptors or the plastic
sleeves included. Select the most appropriate coupling to fit your pram / stroller’s rear axle or tube diameter. To install
the adaptor, pull and hold the trigger back while sliding your adaptor upward onto the coupling wire. Repeat for the
other side.
IMPORTANT NOTE: If an adaptor is not required to fit your stroller, we recommend covering the wire
with the plastic sleeve to avoid cosmetic damage to your stroller
C. The coupling parts (6-7) have already been pre-assembled by the manufacturer as Figure C.
D. Measure the axle height of your pram. Insert the bolt of the coupling plate (7) into the most appropriate hole (height
wise) in the “L” attachment (9). Secure with the locking nut (8). Your “L” attachment can be assembled facing upwards
or downwards depending on the axle height required to ensure that, when assembled, your Junior Rider will be as
parallel to the ground as practicable.
E. Fix the foot-board (1) to the “L” attachment (9) using the bolts and washers (10).
F. Fix the foot-board (1) under the “L” attachment (11) using the bolt and washer (10) provided.
G. Now adjust the Junior Rider width to the width of the pram, adjusting it as far as is possible (12). Tighten all bolts to fit
the width to this position. Your Junior Rider is now ready for use.
H. If the Junior rider is temporarily not in use, it can be hooked up behind your stroller. Clip the hook onto the platfform
and attach the strap to a higher point on your stroller. (13).
Parts List
coupling plate
(Pre assembeled)
2 x plastic
sleeves
3 x set adaptors
‘L’ plate
2 x wheels
tether strap
anti slip board
2 x wheel bolts
2 x wheel nuts
2 x nuts
& washers
1 x bolt
& washer
2 x bolts & washers
assembly tools
