5
/
9
If you need to extend the communication cable connection, the male and female 3-pin XLR plugs at both
ends of a corresponding 1,2 corresponding 2,3 corresponding 3, otherwise easily lead to a communication
break. (Note: Each cables with a core diameter should be at least 0.5mm, best to use dual-core shielded
cable).
When the computer lights signal line access or take out, you should use a cylindrical 3-pin XLR plugs and
fixtures be provided. Note that all 3-pin XLR internal wires should not touch each other or come into
contact with the plug body.
The fixtures can accept DMX512 digital control signal format, the control signal socket connected to
labeled "IN" panel, and then mark it from there "OUT" socket connected to the next fixtures "IN" socket .
When installation is recommended to use DMX signal terminator. It is possible to avoid the damage
caused by electrical noise digital control signal. In simple terms, DMX terminator is a XLR connector,
between its 2 pin and 3 pin have a 1W and 120
ohm resistor, connect it to the computer lights chain last computer lights OUT socket.
The lamp is turned on methods
After completing all of the above operations and ensure that the corresponding model bulbs installed,
press the power switch to check whether everything is normal. After the switch is turned on before the
computer is lit lamp. The fixtures start after a few seconds mechanically reset setting operation, since after
the inspection, the LCD shows the DMX signal the start-coded values.
Menu Structure
Front cover-- Set up ---Run mode
DMX location
Channel Mode
X Reversion
Y Reversion
Y Reversion
XY Encoder
Not DMX Signal
Screen Saver
Boot then lamp comes on
Color wheel linear change
Manual Restore Default Settings
Options
Explanation
Run mode
DMX
From the machine Status
：
receive DMX signals from a control
station or host
Self-propelled1
host hospital switch Status
：
Self-propelled and sends a DMX
signal to the slave
Self-propelled2
Self-propelled3
Self-propelled4
Painting 8
Painting ago 0
