24
16.0 OPTIONS, TURF HOLD-DOWN KIT.
3
2
1
Fig. 18
You can use a turf hold-down kit when the turf layer comes loose.
2 Turf Hold Down Kits are available:
•
For the 12 mm (1/2”) pins, number 211.712.002
•
For the 18 mm (3/4”) pins, number 211.712.004
The Verti-Drain 7120 is equipped standard with a pre-mounted main beam on which the turf
hold-down fingers can be mounted.
The kit consists of a set of turf hold-down fingers for 12 mm (1/2”) or 18 mm (3/4”) pins and
the mounting material consisting of a number of bolts and nuts.
INSTALLATION OF THE TURF HOLD-DOWN KIT (see fig. 18):
-
The ordered set comes with plates 2. Fasten the plates to the main beam with bolt 3 and
nut 1. Align the plates with the pins through the slotted holes in the plates.
-
When the plates have been in use for some time and are bent in one direction, reverse
their direction.
OTHER SUGGESTIONS:
-
When the pins no longer sit in the middle of the machine, they may contact the sides of
the slots. Re-align the pin blocks.
-
If the pins contact the front side of the hole (during use), check the length of the drawbar.
Never crawl under the machine. Make sure the machine is properly blocked!
