15
3 INSTALLATION
3.8
Turning The Inverter On
3.8.1 Switch Controls
With the DC cables and Chassis Ground point correctly installed the switch on the inverter can be turned
ON to the single line side. The second ON switch is to be used ONLY when controlling the inverter from
two locations
3.8.2 LEDs and Connecting AC
The LED will illuminate green once switching the inverter on. If the inverter status is not green refer to
Section 2.1.3 (page 8).
If the LED is green, switch unit OFF, it is safe for installer to plug the AC cord(s) into the GFCI socket(s)
connect loads to the Inverter AC output. Turn the inverter switch to ON.
FIGURE 3.8.1:
Switching Inverter ON
FIGURE 3.8.2:
Correct Inverter Status
3.9
Connecting AC
If all LEDs are green, switch unit OFF, it is safe for installer to plug the AC cord(s) into the GFCI socket(s)
connect loads to the Inverter AC output. Turn the inverter switch to ON.
3.10 Maintenance
Turn the unit OFF before cleaning. Very little maintenance is required to keep the inverter operating
correctly. The exterior of the inverter should be cleaned periodically with a damp cloth to prevent
accumulation of dust and dirt. At the same time, tighten the screws on the DC input terminals.
A V ACuum cleaner can be used to remove dust from ventilation openings and fan area.
Summary of Contents for R-12-400RS-NA
Page 1: ...RS Series 12V Inverters R 12 400RS NA ...
Page 19: ...18 NOTES ...
