Mounting the PowerDock | 11
Mounting Steps
WARNING
Use suitable Personal Protective Equipment
(PPE) when operating power tools.
1.
Confirm that the clearances around the Dock are adequate; see
. Check that there is enough clearance above the Dock by fully opening
the Handle.
2.
Position the Dock in its final location and mark the centre of each mounting hole.
At least 1
hole at each of the 6 mounting hole locations must be used
, for a total of 6 bolts.
3.
Drill the holes — check first that the reverse side of the mounting surface is clear before drilling
any holes to avoid drilling into any object accidentally.
De -burr the drilled holes and clear away swarf. To prevent rust, touch up any exposed bare
metal surfaces with a rust inhibitor (e.g. primer).
Mounting Hole locations in the PowerDock base. One hole from each location must be used.
1
2
3
4
5
6
