COPYRIGHT © 2015 RED.COM, INC
RED MOTION MOUNT OPERATION GUIDE
955-0013, REV-J | 25
STORAGE INSTRUCTIONS
Follow these instructions to protect the RED MOTION MOUNT
®
when not in use:
Protect the MOTION MOUNT while not in use by replacing the DSMC
®
Mount Body Cap and the DSMC
Mount Back Cap.
Store the MOTION MOUNT in a clean, dry environment.
CLEAN MOTION MOUNT GLASS
As with all optical glass, any type of physical contact with the glass may scratch or damage the surface. RED
®
recommends that you clean the MOTION MOUNT glass using physical contact only if absolutely necessary.
Before cleaning the MOTION MOUNT glass with swabs or wipes and a cleaning solution, ALWAYS use an
air bulb to remove any solid particles. Cleaning the MOTION MOUNT glass without removing solid particles
increases the risk of scratching the optical surface.
WARNING:
Handle the MOTION MOUNT glass carefully. Failure to follow proper cleaning instructions may scratch
or damage the optical surface.
GENERAL CLEANING INSTRUCTIONS
Avoid using the MOTION MOUNT in dusty or hazardous environments.
Avoid physical contact with the glass.
DO NOT rinse the MOTION MOUNT or immerse it in water.
DO NOT use compressed air to clean the MOTION MOUNT.
DO NOT use soaps, detergents, ammonia, alkaline cleaners, or abrasive cleaning compounds to clean the
MOTION MOUNT.
DO NOT apply cleaning solution directly to the MOTION MOUNT glass.
DO NOT use an excess of cleaning solution.
DO NOT reuse swabs or wipes.
AIR BULBS
Use a rubber air bulb to remove any solid particles, such as dirt or dust. Use an ionized air bulb to remove solid
particles as well as static build-up.
WARNING:
DO NOT use compressed air and gas dusters to clean the MOTION MOUNT, since the high pressure,
oily residue, cold air, particulates, and moisture may cause damage. Damage to the MOTION MOUNT or any
components of the camera system caused by using compressed air or gas dusters is not covered under
warranty.
04
MOTION MOUNT
MAINTENANCE