RED MOTION MOUNT OPERATION GUIDE
COPYRIGHT © 2015 RED.COM, INC
955-0013, REV-K | 11
3. Replace and loosely tighten the four (4) M4x0.7 x 8 mm lens mount screws in a cross pattern (“X” pattern).
WARNING:
DO NOT FULLY TIGHTEN.
4. Tighten the four (4) lens mount screws evenly using a T20 TORX driver in a cross pattern (“X” pattern). DO
NOT exceed 350 in-oz, or damage may occur.
WARNING:
DO NOT OVERTIGHTEN.
NOTE
: The DSMC Mg PL Mount 2.0 has captive screws that are not removable from the mount.
5. After installation, a hardware rediscover or firmware upgrade may be required. If the MOTION MOUNT is
not recognized, you are unable to access the MOTION MOUNT menu at
Menu
>
Settings
>
Setup
>
Lens
.
To perform a hardware rediscover, go to
Menu
>
Settings
>
Maintenance
>
Rediscover
. A system reboot is
required after a hardware rediscover.
NOTE:
For more information and troubleshooting, go to
“Camera Does Not Recognize the MOTION MOUNT” on
NOTE:
If you need to replace any screws, please contact your Bomb Squad representative.
Install Screws
