8
•
•
•
•
•
•
•
Match-Lighting
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Turn controls and gas source or tank OFF when not
in use.
WARNING
4.
Push in and turn the AUTO-CLEAN™ valve to the
COOK
position.
Turning the Grill OFF with AUTO-CLEAN™
With the Autoclean feature you have two choices for turning off
your grill;
Manual
and
AUTO-CLEAN™
Manual Method
Turn all knobs, including the AUTO-CLEAN™ valve, to the
OFF
position.
Turn
OFF
the LP cylinder by turning the handwheel
clockwise to a full stop.
AUTO-CLEAN™ Method
•
After cooking is complete, set all main burner grill knobs to the
setting and close the grill lid. (AUTO-CLEAN™ shutdown
should not be used on the sideburner.)
Push in and turn the AUTO-CLEAN™ knob to the
CLEAN
position.
Once at the
CLEAN
position, release the knob and the green light
should begin blinking.
The valve will now stay on for 15 minutes before turning off the
gas to the burners.
After the clean cycle is complete, turn all knobs including
the AUTO-CLEAN™ valve to the
OFF
position.
Turn
OFF
the LP cylinder by turning the handwheel clockwise
to a full stop.
For safety in storing a grill, the LP cylinder should always be turned
OFF.
If red light comes on while green light is flashing, the batteries will
need to be replaced very soon.
Ignitor Check
• Turn gas off at LP cylinder.
Press and hold electronic ignitor
button. "Click" should be heard and spark seen each time
between each collector box or burner and electrode. See
"Troubleshooting"
if no click or spark.
Valve Check
• Important: Make sure gas is off at LP cylinder before
checking valves
. Knobs lock in
position. To check
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to
LOW
position then turn back to
position. Valves should turn smoothly.
Hose Check
•
Before each use, check to see if hoses are cut or worn.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified by manufacturer.
OFF
OFF
Do not lean over grill while lighting.
3.
Open lid during lighting
.
5.
Place match into match holder (hanging from side of cart).
Light match, place into lighting hole on right or left side of
firebox.
6 .
Push in and turn far right or far left knob to
position. Be
sure burner lights and stays lit.
7.
If ignition does NOT occur in 5 seconds, turn the burner
control knob
OFF
, wait 5 minutes, and repeat the lighting
procedure.
8.
Light other burners by pushing knob in and turning to
position. If your grill has two cooking zones, repeat steps 4
1.
Turn
OFF
all gas burner control valves.
2.
Turn
ON
gas at LP cylinder.
through 6 for the remaining section of the grill.
Side Burner Lighting Instructions:
s
Do not lean over grill while lighting.
1. Turn
OFF
all gas burner control valves.
2. Turn
ON
gas source or tank.
3. Open lid during lighting.
4. Push in and turn AUTO-CLEAN
™
valve to
COOK
position.
5. To ignite SIDEBURNER, turn sideburner knob to the
position.
6. Push and hold the ELECTRONIC IGNITOR button untill the
sideburner lights.
7. Once burner has ignited, turn knob to desired setting.
8. If ignition does not occur in 5 seconds, turn the burner control
to
OFF
, wait 5 minutes, and repeat the lighting procedure.
Sideburner Match Lighting
1.
2. Open sideburner lid. Turn on
gas at LP cylinder.
3. Place lit match near burner.
4. Turn sideburner knob to .
Be sure burner lights and stays lit.
Turn
OFF
all burner control valves.
Burner Flame Check
•Remove cooking grates and troughs. Light burners, rotate
knobs from to . You should see a smaller flame in
position than seen on . Perform burner flame check
on sideburner, also. Always check flame prior to each use. If
only low flame is seen refer to "Sudden drop or low flame" in
the
Troubleshooting Section
.
When changing the batteries, please replace both batteries at the
same time. Always replace with new batteries of the same type.
NOTE:
Always follow the lighting instructions found in the
instruction manual and also located on the inside of the cabinet
door prior to using the Auto-Clean feature. Grill must be ignited
prior to using the Auto-Clean feature.
