PART VOICE SELECT:
CREATE NEW PART VOICE:
1. [PART] MENU:
2. [MIDI] MENU:
3. [PART OUTPUT]:
You can load-in single voices to the current program PART from any other program
location. In this way you can easily find favourite sounds stored in other programs and import them into the
program currently being created/edited.
To change the selected PART voice, press and hold the [PART] button for a short period. The indicator will start to
flash to show ‘PART LOAD’ mode, as shown in the following example:
The main display will change to show the current PART voice number [01 to 321 - this equates to 5 PART voices in
each of the 64 program memory e.g. 320 sounds].
Use the [VOICE/PROGRAM] jog dial to change the voice as follows:
There will be a short delay at every fifth voice load whilst the software brings in the next whole program (5 voices)
from memory. The display will briefly show ‘LOAD’ when this occurs. Once the desired voice is loaded remember to
carry out a SAVE procedure to store the new setup in memory. To cancel PART VOICE SELECT mode at any time
simply press a [PART] or [MENU] button.
Before creating a brand new sound for a PART you must first setup the basic
‘structure’ which defines how the PART is played and what limitations will apply in relation to the other PARTS. The
following functions and associated parameters can be set for each part, namely:
POLYPHONY, KEY TRANSPOSE, NOTE RANGE (LOW), NOTE RANGE (HIGH),
PAN SOURCE, TREMOLO SOURCE and CHORUS EFFECT
MIDI CHANNEL, SUSTAIN, PITCH BEND RANGE
OUTPUT LEVEL, PANNING LEVEL / SOURCE, TREMOLO LEVEL / SOURCE
PORTAMENTO LEVEL / TYPE, AUTO-GLIDE ON/OFF
PARAMETER
VALUE
Rotate the JOG DIAL
to change the VOICE
New setting =
PART Voice number 101
[from Prog 20/Part1]
VOICE/
PROGRAM
[+/up]
[-/dwn]
2
1
PART SELECT
3
5
4
Press & hold
Flash = ‘PART LOAD’ mode
Example = PART Voice number 11
[Prog 3/Part1]
PARAMETER
VALUE
OWNERS MANUAL
21
PA
G
E
Operation
